Flap disc
HERMAN LR-10 Basic
For stainless steel | Flap width 35mm

Flap width 35mm:
increases the active grinding surface, thereby extending the disc’s service life during grinding

Recommended angle for machining 15˚ - 25˚:
the conical shape of the T29 disc pad in combination with the radially arranged lamellae significantly increases the contact area

Primary raw material - high-quality sanding belts with an applied layer of zirconium corundum abrasive grains (50% zirconium):
long service life and very good material removal when machining stainless steel and higher strength steels

Lamellas machine-cut from sanding belts and laid radially around the perimeter with an accuracy of 0.5mm:
precise final product for efficient work

Plate mat made of 7-layer fiberglass:
high structural safety and destruction resistance

Special glue based on epoxy resin:
for a secure connection of the slats to the base plate

Optimal number of lamellae for efficient machining:
chosen depending on the diameter and grain size of the tool

The grain size is standard in the range of P40 to 120 according to FEPA (100 to 500 µm):
enables the selection of a suitable tool from rough grinding to fine finishing work