Cleaning grinding wheel
HERMAN KY-61 Dragon
For removing rust

Available in 2 variants Ø115 and 125mm:
due to the universality of use, it is sufficient for the entire range of rough cutting operations

Sanding body with considerable elasticity:
ideal for cleaning even highly fragmented substrates

Spacious, 13mm thick porous grinding structure:
minimizes clogging of the grinding part with dirt, good removal of heat and grinding dust outside the grinding body

Permanent structure of the polyamide sanding part:
does not change under the influence of sanding, which allows repeated use with undiminished performance

Recommended machining angle 5˚ - 15˚:
the flat shape of the T27 disc pad in combination with the radially arranged lamellae enable machining with a contact surface centered in a line

Primary raw material - polyamide elastic material impregnated with coarse-grained silicon carbide:
universal use largely depends only on the grinding pressure and the speed of the angle grinder

Special glue based on epoxy resin:
for a secure connection of the grinding body to the backing plate

Plate mat made of 7-layer fiberglass:
high structural safety and destruction resistance

Recommendation:
to achieve the best results, it is advisable to use a 125mm angle grinder with regulation and an input power of at least 1400W. The optimal machining speed is 2,800 - 4,000 rpm.