
Four-point TCT drill bit set
HERMAN QDC-61 Glass
5pcs drill bits in set
Set of HERMAN DC-61 Glass four-point drill bits for glass and ceramics with specially ground carbide inserts : Ø 3, 4, 5, 6, 8mm
Suitable equipment
Designation
- For drilling in glass, ceramics, tiles, mirror glass, porcelain, etc.
- Suitable for drilling without hammering with conventional electric drills and cordless drilling screwdrivers
Description
Large main and two side cutters made of sintered carbide with tungsten:
a special, improved version of the drill bit (conventional glass drills are equipped with only one - main cutter)
Cross-shaped tip with 90° blade spacing:
minimises cracking of the substrate material even with inadvertent higher drilling pressure
1/4" shank (6.35mm OD hexagon):
allows use in three jaw chucks and also in screwdrivers with 1/4" quick-release system
Recommendation:
when drilling, proceed slowly, do not push and drill without hammering. Choose a low speed, for a range of 3 - 8mm drill at approx. 100-400 rpm. The smaller the diameter, the higher the speed and vice versa. When drilling, cool the working part of the drill bit with water if possible, a continuous, small stream of water is best
Contents of the package
- Four-cutter TCT Drill bit 3, 4, 5, 6, 8mm 1pc
- 1x Plastic case
Questions and answers
Karol Bryndzák
technical consultant
Marek Baláž
manažér úseku opráv
International









Joe –
Kvalitné prevedenie vrtákov a aj krabičky.
High-quality design of the drills and the box.
Translate text Show originalGabriella Kissné Varga –
szuper
super
Translate text Show originalJakub Trešl –
Suprová sada , jak pro vrtání do velmi tvrdého obkladu, nebo dlažby. Sklo také není problém.
A drill set for drilling into very hard tiles or paving. Glass is also no problem.
Translate text Show original