Grinding wheel
HERMAN GS-50 GrindSlim
Steel standard

Recommended grinding angle:
25˚ - 35˚

Very good ratio between material removal rate and wheel life:
effective alignment of these two conflicting requirements is achieved by proprietary production formulas with a balanced ratio of seven raw materials and additives

Disc thickness 4mm:
lower tool weight - greater working comfort, especially when working overhead or in hard-to-reach places

If necessary, the possibility of using a cutting tool:
the smaller thickness of the disc allows cutting of material to a limited extent, especially thick-walled materials

Main raw material:
aluminium oxide abrasive grains (industrially produced corundum) with a size of 700 to 850 µm, i.e. grain size F24 according to FEPA

Higher porosity of the internal structure of the disc:
faster removal of the processed material

Additives with lubricating and cooling properties:
reduce heating of the workpiece and energy requirements during grinding

High disc safety:
reinforcement with three solid fiberglass grids impregnated with resin, pressed under high pressure and hardened in ovens for more than 30 hours