Combi-hammer
HERMAN BXH-10 | SDS-plus
850 W

3+1 position switch of operating modes:
drilling with hammer, drilling without hammer, hammer without turning the tool for chopping work and mode for setting the position of the chisel

Ergonomic side handle with a rubberized grip surface, removable without tools, adjustable in the range 0-360°:
allows you to grip the hammer safely while working and to set a comfortable handle position

Optimized, ergonomically shaped rear handle with non-slip rubberized surface:
comfortable, pleasant grip

Switch with locking in the on position:
if needed, it is not necessary to hold the index finger of the hand on the switch while working

Variable speed with a regulator built into the switch:
It enables precise guidance of the drill when drilling holes

Switching between right and left rotation with the carbon brush feed switch:
a unique technical solution for equal torque in both directions of rotation, particularly useful for loosening long drill bits from deep holes and for some screwdriving applications with the appropriate adapter (included)

10-position chisel adjustment:
increases productivity by allowing you to adjust the position of flat, paddle and channel chisels

Continuously adjustable depth stop in the range from 0-180 mm:
for serial drilling of holes of the same depth

Light alloy gearbox:
reduces the weight of the hammer

Commutator protection:
the carbon brush holder design minimizes the possibility of commutator damage

Dust-tight clamping:
a special flexible seal reduces the permeability of dust to the quick-clamping mechanism and thus extends its service life

Safety slip clutch:
in the event of a sharp collision of the drill, the clutch disconnects the motor from the gearbox and protects it from overload

Gearbox made of light alloy:
the material used contains additives that increase resistance to wear

Effective anti-dust system reduces the penetration of dust during the intake of cooling air

Specially shaped air inlets increase the efficiency of engine cooling

• 1x Electropneumatic hammer
• 1x Additional handle
• 1x Depth stop
• 1x Briefcase
• 1x Lithium plastic grease MT-21
• 1x Quick-release chuck BF-31 Black&Red ½ʺ for drilling without electro-pneumatic impact
• 1x Adapter SDS-plus / ½ʺ- 20 UNF DC-80 with external thread for three-jaw chuck
• 1x SDS-plus /1/4" HEX adapter DC-81 with internal hexagon for screw bits
• 1x Instructions for use